VW Fault Code 14947 for Volkswagen Type 3

The fault code 14947 in a Volkswagen Type 3 typically refers to a malfunction detected by the vehicle’s onboard diagnostics system (OBD). It may relate to the engine, transmission, or emissions components. The purpose of this page is to help Volkswagen Volkswagen Type 3 owners interpret the meaning of the 14947 trouble code, recognize its symptoms, and identify the most likely causes and fixes.

Possible Causes:

vw fault code may be caused by one or more of the following:

Common Causes of VW Code 14947 in Volkswagen Type 3

• Faulty or dirty engine sensor (e.g., oxygen, crankshaft, or MAP sensor)
• Damaged wiring harness or poor electrical connections
• Low oil pressure or contaminated engine oil
• Blocked intake or exhaust components
• Fault in ECU or control module calibration

Typical Symptoms for Volkswagen Type 3

• Check Engine Light illuminated
• Rough idling or hesitation during acceleration
• Decreased fuel efficiency
• Reduced engine performance or limp mode
• Difficulty starting the vehicle

Recommended Fix Steps for Volkswagen Type 3

1. Perform an OBD-II scan and confirm the code 14947
2. Inspect wiring and connectors related to the affected system
3. Clean or replace sensors such as the oxygen or crankshaft position sensor
4. Reset the fault codes and test drive the vehicle
5. If the issue persists, consult a certified VW technician