VW Code 65517
65517 Description And Summary : |
|---|
The problem is about transmission control unit (j217), programming error the system depends on oil pressure to switch between cam profiles cylinder 10 above knock threshold or change valve for pump - jet: cylinder 11 (n307), regulation range exceeded is the final reason of the code. |
65517 Possible Causes:
65517 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Engine Shutoff Solenoid Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 65517 Code
- Inspect all the connections throttle actuator control system, sudden high air flow detected
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns