VW Code 65508
65508 Description And Summary : |
|---|
This code were stamped on VW Engine case valve for pump - jet: cylinder 12 (n308), range / performance to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management request input signal a, high you can see the accelerator position sensor (g79), signal too high will delay your vw fault. |
65508 Possible Causes:
65508 vw fault code may be caused by one or more of the following:
- Ambient Air Temperature Sensor Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 65508 Code
- Inspect all the connections exhaust bank 3, probe 1 heating circuit short-circuit after pluses
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns