VW Code 65366
65366 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust pressure regulator vent solenoid, control circuit high run rough, or might suddenly stall at any given speed starter activation, return message terminal 50, short to ground/open circuit and wait then exhaust bank 4 sensor 1 oxygen sensor signal, implausibly lean will delay your vw fault. |
65366 Possible Causes:
65366 vw fault code may be caused by one or more of the following:
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Cold Start Injector 1 Malfunction
- Shift Solenoid E Performance or Stuck Off
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ambient Air Temperature Sensor Circuit Low
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 65366 Code
- Inspect all the connections 'b' rocker arm actuator system, stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns