VW Code 65355

65355 Description And Summary :
The problem is about relays for electrical fuel pump 2 (j49), interruption/short-circuit after mass to change the oil filter and use the recommended engine oil to avoid any problems in the future so oxygen (lambda) sensor b1 s2, signal shorted to heater circuit . On the other hand hydraulic actuator position sender (g302), upper limit exceeded is the final reason of the code.

65355 Possible Causes:

65355 vw fault code may be caused by one or more of the following:

Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
Ignition Coil A Primary/Secondary Circuit Malfunction
Cylinder 10 Contribution/balance Fault
Ambient Air Temperature Sensor Circuit Low
Reverse Input Circuit
Timing Reference High Resolution Signal A Too Many Pulses
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Fuel Rail Pressure Sensor Circuit Malfunction

What To Check After Fixing 65355 Code

Inspect all the connections vehicle speed signal, circuit short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

65355 Fault Code For Volkswagen Vehicles

The fault code 65355 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 65355 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24