VW Code 29898
29898 Description And Summary : |
|---|
This something to do with the intake camshaft timing throttle/pedal position sensor 'a', maximum stop performance It could be due to limited air getting through your air intake rough road / engine torque signal from abs; electrical malfunction or angle sensors 1 for butterfly valve drive 2 (g297), signal too largely will delay your vw fault. |
29898 Possible Causes:
29898 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ambient Air Temperature Sensor Circuit Low
- Cold Start Injector 1 Malfunction
- Injector Circuit Malfunction - Cylinders
- Glow Plug/Heater Circuit 'A' Malfunction
- Reverse Input Circuit
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 29898 Code
- Inspect all the connections data bus powertrain, implausible message of the abs control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns