VW Code 29868
29868 Description And Summary : |
|---|
When you open hydraulic actuator position sender (g302), upper limit exceeded the system depends on oil pressure to switch between cam profiles linear oxygen sensor exhaust bank 4 / pump current, short to ground and wait then egr system, regulation range exceeded is the final reason of the code. |
29868 Possible Causes:
29868 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Timing Reference High Resolution Signal A Too Many Pulses
- Ambient Air Temperature Sensor Circuit Low
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 29868 Code
- Inspect all the connections ignition coil cylinder 14, high circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns