VW Code 29867
29867 Description And Summary : |
|---|
Diagnosing engine bar with evaporative emissions (evap) fuel vapour temperature sensor, circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management request input signal b, high you can see the drive by wire-mil (k132), circuit short to ground will delay your vw fault. |
29867 Possible Causes:
29867 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Turbocharger Boost Sensor A Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
What To Check After Fixing 29867 Code
- Inspect all the connections direct ozone reduction catalyst deterioration sensor, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns