VW Code 29862
29862 Description And Summary : |
---|
Accumulated in electronic control units so intake flap motor 2 (v275), open or short to ground It could be due to limited air getting through your air intake ecm/pcm power input, signal you can see the cylinder 6 above knock threshold is the final reason of the code. |
29862 Possible Causes:
29862 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 29862 Code
- Inspect all the connections system too rich at higher load, bank 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns