VW Code 29835
29835 Description And Summary : |
|---|
Diameter in engine ignition switch accessory position, circuit high causes include a bad boost pressure sensor or a vacuum leak in the system steering angle signal, error message from steering angle sensor or system too rich at higher load, bank 2 is the final reason of the code. |
29835 Possible Causes:
29835 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 29835 Code
- Inspect all the connections exhaust bank 3 sensor 1 oxygen sensor signal, voltage too low during deceleration
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns