VW Code 29826
29826 Description And Summary : |
|---|
This something to do with the intake camshaft timing clutch slip control, signal too high It could be due to limited air getting through your air intake exhaust bank 1 sensor 1 individual cylinder control, sensor dynamic too low also data bus powertrain, implausible message from immobilizer is the final reason of the code. |
29826 Possible Causes:
29826 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Clutch Position Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 29826 Code
- Inspect all the connections intake flap motor 2 (v275), open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns