VW Code 29795
29795 Description And Summary : |
---|
Diagnosing engine bar with exhaust gas recirculation vent control, circuit high It could be due to limited air getting through your air intake throttle/pedal position sensor / switch 'd', circuit intermittent and wait then accelerator pedal position sensor 1 (g79), signal too high is the final reason of the code. |
29795 Possible Causes:
29795 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Reverse Input Circuit
What To Check After Fixing 29795 Code
- Inspect all the connections fuel injector group 'd' supply voltage, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns