VW Code 29764
29764 Description And Summary : |
---|
This code were stamped on VW Engine case angle sensors 1 for butterfly valve drive 2 (g297), signal too largely causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 3, probe 2 tension too largely and wait then load signal, error message from ecu is the final reason of the code. |
29764 Possible Causes:
29764 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- O2 Sensor Heater Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Turbocharger Boost Sensor A Circuit Low
- Cylinder 1 Injector Circuit Low
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Reverse Input Circuit
What To Check After Fixing 29764 Code
- Inspect all the connections glow plug/heater relay 2 circuit, open or short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns