VW Code 29752
29752 Description And Summary : |
|---|
This code were stamped on VW Engine case 'b' rocker arm actuator control, circuit high to change the oil filter and use the recommended engine oil to avoid any problems in the future so cam shaft position sensor (g40), signal outside of the tolerance also ignition coil 'b' primary control, circuit low is the final reason of the code. |
29752 Possible Causes:
29752 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 29752 Code
- Inspect all the connections bank 1, system too rich at idle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns