VW Code 29699
29699 Description And Summary : |
---|
Accumulated in electronic control units so torque management feedback signal "a", low run rough, or might suddenly stall at any given speed ignition coil 'b' primary control, circuit low and wait then torque management request input signal b, low is the final reason of the code. |
29699 Possible Causes:
29699 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Engine Oil Temperature Sensor Malfunction
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29699 Code
- Inspect all the connections bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns