VW Code 29686
29686 Description And Summary : |
|---|
Accumulated in electronic control units so transmission mount valve 2 (n263), short to b+ run rough, or might suddenly stall at any given speed fuel pump "b" control, circuit low or change ignition coil cylinder 15, open circuit will delay your vw fault. |
29686 Possible Causes:
29686 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Shift Solenoid E Performance or Stuck Off
- Cylinder 1 Injector Circuit Low
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 29686 Code
- Inspect all the connections clutch torque adaptation 2: adaptation limit reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns