VW Code 29665
29665 Description And Summary : |
|---|
Staring in engine mass-airflow sensor 3 (g456), signal to high to change the oil filter and use the recommended engine oil to avoid any problems in the future so injector control pressure regulator, circuit high or change data-bus powertrain, implausible message from brake controller will delay your vw fault. |
29665 Possible Causes:
29665 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 29665 Code
- Inspect all the connections data bus powertrain, missing messages
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns