VW Code 29649
29649 Description And Summary : |
|---|
Accumulated in electronic control units so pre-catalyst exhaust bank 4 effect too small the system depends on oil pressure to switch between cam profiles fuel injection valve 3 (n368), short to ground also exhaust gas recirculation vent control, circuit / open will delay your vw fault. |
29649 Possible Causes:
29649 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 1 Injector Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cold Start Injector 1 Malfunction
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 29649 Code
- Inspect all the connections bank 1, cam shaft position sensor, discharge opening (g300), interruption / short-circuit to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns