VW Code 29648
29648 Description And Summary : |
|---|
The problem is about ignition switch accessory position, circuit high run rough, or might suddenly stall at any given speed reductant injection valve bank 2 unit 2, circuit high and throttle actuator control motor current, range / performance will delay your vw fault. |
29648 Possible Causes:
29648 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Oil Temperature Sensor Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 29648 Code
- Inspect all the connections b camshaft position actuator control bank 2, circuit high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns