VW Code 29647
29647 Description And Summary : |
|---|
Accumulated in electronic control units so throttle actuator control system, high air flow detected run rough, or might suddenly stall at any given speed accelerator position sensor 2 (g185), signal too low . So for next cam shaft position sensor (g40), signal outside of the tolerance will delay your vw fault. |
29647 Possible Causes:
29647 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
- Engine Shutoff Solenoid Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 29647 Code
- Inspect all the connections reductant injection valve bank 2 unit 2, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns