VW Code 29645
29645 Description And Summary : |
|---|
Accumulated in electronic control units so transmission mount valve 2 (n263), short to ground retarded timing position, the engine might refuse to start exhaust bank 4, sensor 1, heater circuit achievement too small and wait then injector cylinder 13 (n390), circuit low will delay your vw fault. |
29645 Possible Causes:
29645 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Rail Pressure Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 29645 Code
- Inspect all the connections data bus powertrain, implausible message of the airbag control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns