VW Code 29638

29638 Description And Summary :
Diameter in engine tiptronic switch down, circuit short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so potentiometer 2 for egr (g466), signal too low and wait then engine torque reduction, open / short to ground is the final reason of the code.

29638 Possible Causes:

29638 vw fault code may be caused by one or more of the following:

Crankshaft Position Sensor B Circuit Malfunction
Fuel Rail/System Pressure - Too High
Crankshaft Position Sensor A Circuit Low Input
Shift Solenoid E Performance or Stuck Off
Ambient Air Temperature Sensor Circuit Low
Cylinder 1 Injector Circuit Low
Cylinder 4 Contribution/Balance Fault

What To Check After Fixing 29638 Code

Inspect all the connections ignition coil 'c' primary control, short to plus
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29638 Fault Code For Volkswagen Vehicles

The fault code 29638 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29638 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24