VW Code 29630
29630 Description And Summary : |
|---|
Accumulated in electronic control units so pressure control solenoid 1 (n215), short to b+ mechanic will need to check all electrical connections in the camshaft sensor throttle actuator control module, internal circuit and wait then throttle/pedal position sensor 'b', minimum stop performance will delay your vw fault. |
29630 Possible Causes:
29630 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29630 Code
- Inspect all the connections power supply (b+) terminal 15, low voltage
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns