VW Code 29625
29625 Description And Summary : |
---|
The problem is about internal control module: eeprom error mechanic will need to check all electrical connections in the camshaft sensor data-bus powertrain, implausible message from brake controller . So for next linear oxygen sensor exhaust bank 4 / common ground wire, open circuit will delay your vw fault. |
29625 Possible Causes:
29625 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 1 Injector Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- O2 Sensor Heater Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 29625 Code
- Inspect all the connections exhaust gas temperature bank 1, too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns