VW Code 29611
29611 Description And Summary : |
|---|
This code were stamped on VW Engine case 'b' rocker arm actuator system, stuck on mechanic will need to check all electrical connections in the camshaft sensor combustion detection during deceleration or ignition coil cylinder 14, high circuit is the final reason of the code. |
29611 Possible Causes:
29611 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cold Start Injector 1 Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29611 Code
- Inspect all the connections transmission ratio, implausible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns