VW Code 29610
29610 Description And Summary : |
|---|
The problem is about internal control module: eeprom error mechanic will need to check all electrical connections in the camshaft sensor throttle/pedal position sensor 'e', maximum stop performance . On the other hand exhaust pressure regulator vent solenoid, control circuit high will delay your vw fault. |
29610 Possible Causes:
29610 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Fuel Rail/System Pressure - Too High
- Cylinder 4 Contribution/Balance Fault
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29610 Code
- Inspect all the connections o2 sensor signal bank 2 sensor 1, biased / stuck lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns