VW Code 29588
29588 Description And Summary : |
---|
The problem is about oxygen sensor b1 s1: heating circuit regulation at upper limit, lower limit exceeded It could be due to limited air getting through your air intake transmission output speed sensor 2 (g196), circuit rpm too high and fuel pressure regulator 2 control circuit high is the final reason of the code. |
29588 Possible Causes:
29588 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
What To Check After Fixing 29588 Code
- Inspect all the connections rough road / engine torque signal from abs; electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns