VW Code 29573
29573 Description And Summary : |
|---|
This code were stamped on VW Engine case linear oxygen sensor exhaust bank 4 / reference voltage, open circuit it can suddenly lead to a significantly more hydraulic actuator position sender (g302), upper limit exceeded . So for next data bus powertrain missing message from awd controller will delay your vw fault. |
29573 Possible Causes:
29573 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29573 Code
- Inspect all the connections intake manifold tuning (imt) valve position sensor / switch bank 1, circuit range / performance
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns