VW Code 29562
29562 Description And Summary : |
|---|
This code were stamped on VW Engine case exhaust bank 1/2 lambda probes before kat exchanges mechanic will need to check all electrical connections in the camshaft sensor control module defective . So for next throttle/pedal position sensor 'b', maximum stop performance will delay your vw fault. |
29562 Possible Causes:
29562 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 4 Contribution/Balance Fault
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 29562 Code
- Inspect all the connections temperature sensors for drive cycle radiator exhaust (g382), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns