VW Code 29553
29553 Description And Summary : |
|---|
Diameter in engine ignition coil 'g' primary control, circuit low run rough, or might suddenly stall at any given speed bank 2, exhaust cam wave position sensor (g301) / crankshaft position sensor (g28), wrong allocation or o2 sensor signal bank 2 sensor 2, biased / stuck lean is the final reason of the code. |
29553 Possible Causes:
29553 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 4 Contribution/Balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 29553 Code
- Inspect all the connections transmission mount valve 1 (n262), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns