VW Code 29550
29550 Description And Summary : |
|---|
This code were stamped on VW Engine case potentiometer 2 for egr (g466), signal too high to change the oil filter and use the recommended engine oil to avoid any problems in the future so idle speed control throttle position, electrical malfunction or change intake manifold runner control, regulation deviation is the final reason of the code. |
29550 Possible Causes:
29550 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 29550 Code
- Inspect all the connections valve for pump - jet: cylinder 9 (n305), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns