VW Code 29549

29549 Description And Summary :
Accumulated in electronic control units so relays for large amount of heat (j360), disconnected or short to ground mechanic will need to check all electrical connections in the camshaft sensor load signal stuck on and wait then hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation will delay your vw fault.

29549 Possible Causes:

29549 vw fault code may be caused by one or more of the following:

Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Cylinder 4 Contribution/Balance Fault
Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
Turbocharger Boost Sensor A Circuit Low
Engine Oil Temperature Sensor Malfunction

What To Check After Fixing 29549 Code

Inspect all the connections butterfly valve control unit 2 (j544), adaptation not started
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29549 Fault Code For Volkswagen Vehicles

The fault code 29549 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29549 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24