VW Code 29548
29548 Description And Summary : |
---|
Diagnosing engine bar with turbocharger boost control position sensor, circuit the system depends on oil pressure to switch between cam profiles control circuit for controller for turbocharger 1 (j724): electrical malfunction . So for next hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation is the final reason of the code. |
29548 Possible Causes:
29548 vw fault code may be caused by one or more of the following:
- Fuel Rail Pressure Sensor Circuit Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
- Injector Circuit Malfunction - Cylinders
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
- Shift Solenoid E Performance or Stuck Off
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 29548 Code
- Inspect all the connections secondary air injection system pump bank 1, stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns