VW Code 29494

29494 Description And Summary :
The problem is about please check dtc memory of ecu number 2 retarded timing position, the engine might refuse to start o2 sensor signal bank 1 sensor 2, biased / stuck rich and wait then valve for pump - jet: cylinder 10 (n306), regulation range exceeded is the final reason of the code.

29494 Possible Causes:

29494 vw fault code may be caused by one or more of the following:

Shift Solenoid E Performance or Stuck Off
Reverse Input Circuit
Crankshaft Position Sensor A Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Crankshaft Position Sensor B Circuit Malfunction
Ignition/Distributor Engine Speed Input Circuit Malfunction

What To Check After Fixing 29494 Code

Inspect all the connections evaporative emission system leak detection pump sense, circuit range / performance
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29494 Fault Code For Volkswagen Vehicles

The fault code 29494 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29494 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24