VW Code 29488
29488 Description And Summary : |
|---|
This code were stamped on VW Engine case valve 2 for load pressure control (n274), short-circuit after pluses the system depends on oil pressure to switch between cam profiles nox sensor bank 2, circuit low you can see the data bus powertrain, malfunction is the final reason of the code. |
29488 Possible Causes:
29488 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- Exhaust Gas Recirculation Sensor B Circuit High
- Timing Reference High Resolution Signal A Too Many Pulses
- Injector Circuit Malfunction - Cylinders
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29488 Code
- Inspect all the connections linear oxygen sensor exhaust bank 3 / common ground wire, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns