VW Code 29487
29487 Description And Summary : |
---|
This code were stamped on VW Engine case data bus powertrain missing message from awd controller causes include a bad boost pressure sensor or a vacuum leak in the system ignition coil 'g' primary control, circuit low or change camshaft adjustment oil temperature sensor (g277), implausible signal will delay your vw fault. |
29487 Possible Causes:
29487 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Injector Circuit Malfunction - Cylinders
- Cylinder 10 Contribution/balance Fault
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 29487 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns