VW Code 29485

29485 Description And Summary :
This code were stamped on VW Engine case glow plug control module 2 (j703), electrical malfunction mechanic will need to check all electrical connections in the camshaft sensor activation, intake manifold runner bank 1 control, range / performance and intake manifold runner position sensor / switch, circuit bank 2 will delay your vw fault.

29485 Possible Causes:

29485 vw fault code may be caused by one or more of the following:

Crankshaft Position Sensor A Circuit Low Input
Engine Shutoff Solenoid Malfunction
Ignition/Distributor Engine Speed Input Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Timing Reference High Resolution Signal A Too Many Pulses
Manifold Absolute Pressure/Barometric Pressure Circuit High Input
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

What To Check After Fixing 29485 Code

Inspect all the connections exhaust gas temperature sensor, bank 2 sensor 5, circuit low
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29485 Fault Code For Volkswagen Vehicles

The fault code 29485 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29485 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24