VW Code 29462
29462 Description And Summary : |
|---|
This code were stamped on VW Engine case accelerator pedal position sensor 2 (g185), signal too high run rough, or might suddenly stall at any given speed throttle/pedal position sensor 'a', minimum stop performance . So for next a camshaft position actuator control bank 1, circuit low will delay your vw fault. |
29462 Possible Causes:
29462 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
- Exhaust Gas Recirculation Sensor B Circuit High
What To Check After Fixing 29462 Code
- Inspect all the connections activation intake manifold runner bank 2 control circuit, open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns