VW Code 29450
29450 Description And Summary : |
|---|
Staring in engine engine torque reduction, open / short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so nox sensor bank 2, circuit range / performance or change a/c request a, circuit is the final reason of the code. |
29450 Possible Causes:
29450 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Engine Shutoff Solenoid Malfunction
- Engine Oil Temperature Sensor Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 4 Contribution/Balance Fault
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29450 Code
- Inspect all the connections evaporative emissions (evap) fuel vapour temperature sensor, circuit high voltage
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns