VW Code 29447
29447 Description And Summary : |
|---|
Diagnosing engine bar with exhaust bank 3, probe 1 heating circuit of electrical errors the system depends on oil pressure to switch between cam profiles o2 sensor negative current control bank 2 sensor 1, circuit low or change injector control pressure, too high - engine off will delay your vw fault. |
29447 Possible Causes:
29447 vw fault code may be caused by one or more of the following:
- O2 Sensor Heater Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Exhaust Gas Recirculation Sensor B Circuit High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29447 Code
- Inspect all the connections signal for back-up lights, short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns