VW Code 29433
29433 Description And Summary : |
|---|
This code were stamped on VW Engine case supply voltage for fuel injector group b, open circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so engine torque reduction, short to b+ and wait then intake manifold runner control: open stop outside of valid range will delay your vw fault. |
29433 Possible Causes:
29433 vw fault code may be caused by one or more of the following:
- Reverse Input Circuit
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 10 Contribution/balance Fault
- Shift Solenoid E Performance or Stuck Off
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 29433 Code
- Inspect all the connections intake manifold runner control, circuit high bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns