VW Code 29426
29426 Description And Summary : |
---|
This code were stamped on VW Engine case mil call-up circuit / transmission control module, range / performance It could be due to limited air getting through your air intake hydraulic actuator position sender (g302), implausible signal . On the other hand ng high pressure valve (n372), short to ground will delay your vw fault. |
29426 Possible Causes:
29426 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- O2 Sensor Heater Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 29426 Code
- Inspect all the connections please check dtc memory of all wheel drive ecu
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns