VW Code 29414
29414 Description And Summary : |
|---|
The instrument cluster alerts the driver to the fault data bus powertrain, no message from transmission controller (tcu) run rough, or might suddenly stall at any given speed throttle position (tp) sensor 1-2, correlation or change intake manifold flap; bank 2, stuck closed is the final reason of the code. |
29414 Possible Causes:
29414 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Injector Circuit Malfunction - Cylinders
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Cylinder 10 Contribution/balance Fault
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 29414 Code
- Inspect all the connections motor for intake manifold flap (v157), open / short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns