VW Code 29410
29410 Description And Summary : |
---|
The problem is about relays for pump, fuel cooling (j445), short-circuit after pluses run rough, or might suddenly stall at any given speed torque management feedback signal "b" . On the other hand oxygen (lambda) sensor b2 s2, signal shorted to heater circuit will delay your vw fault. |
29410 Possible Causes:
29410 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Oil Temperature Sensor Malfunction
- Injector Circuit Malfunction - Cylinders
- Crankshaft Position Sensor A Circuit Low Input
- Reverse Input Circuit
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29410 Code
- Inspect all the connections o2 sensor pumping current trim bank 2 sensor 1, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns