VW Code 29393
29393 Description And Summary : |
|---|
Accumulated in electronic control units so injector control pressure regulator, circuit low causes include a bad boost pressure sensor or a vacuum leak in the system egr system, regulation range not reached . So for next ng high pressure valve (n372), open circuit will delay your vw fault. |
29393 Possible Causes:
29393 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 10 Contribution/balance Fault
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 29393 Code
- Inspect all the connections butterfly valve control unit 2 (j544), under voltage during basic adjustment
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns