VW Code 29384
29384 Description And Summary : |
|---|
When you open throttle/pedal position sensor 'd', maximum stop performance run rough, or might suddenly stall at any given speed evaporative emission system leak detection pump control, circuit high or change fuel level sensor 2, circuit will delay your vw fault. |
29384 Possible Causes:
29384 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 1 Injector Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 29384 Code
- Inspect all the connections secondary air injection pump-c-relay (j704), circuit short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns