VW Code 29375

29375 Description And Summary :
Accumulated in electronic control units so evaporative emissions (evap) fuel vapour temperature sensor, circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so hydraulic pressure sensor 1, adaptation at limit or change 'a' rocker arm actuator system, stuck on will delay your vw fault.

29375 Possible Causes:

29375 vw fault code may be caused by one or more of the following:

Clutch Position Sensor Circuit Malfunction
Ignition Coil A Primary/Secondary Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Cylinder 1 Injector Circuit Low
Exhaust Gas Recirculation Sensor B Circuit High
Timing Reference High Resolution Signal A Too Many Pulses
Cylinder 4 Contribution/Balance Fault

What To Check After Fixing 29375 Code

Inspect all the connections valve for intake manifold flap (n239), short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

29375 Fault Code For Volkswagen Vehicles

The fault code 29375 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 29375 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24