VW Code 29365
29365 Description And Summary : |
---|
This code were stamped on VW Engine case drive by wire-mil (k132), circuit short to ground It could be due to limited air getting through your air intake ignition switch run/start position, circuit low . So for next post catalyst fuel trim system, low limit is the final reason of the code. |
29365 Possible Causes:
29365 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail/System Pressure - Too High
What To Check After Fixing 29365 Code
- Inspect all the connections 'a' rocker arm actuator system, stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns