VW Code 29360
29360 Description And Summary : |
|---|
The problem is about bank 1, exhaust cam wave position sensor (g300) / crankshaft position sensor (g28), wrong allocation causes include a bad boost pressure sensor or a vacuum leak in the system b camshaft position actuator control bank 2, circuit high . So for next valve for pump - jet: cylinder 11 (n307), circuit low input will delay your vw fault. |
29360 Possible Causes:
29360 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Reverse Input Circuit
- Shift Solenoid E Performance or Stuck Off
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Cylinder 4 Contribution/Balance Fault
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 29360 Code
- Inspect all the connections o2 sensor reference voltage bank 2 sensor 1, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns