VW Code 29357
29357 Description And Summary : |
|---|
The problem is about reductant injection air pressure sensor 'a', circuit to change the oil filter and use the recommended engine oil to avoid any problems in the future so transmission output speed sensor 2 (g196), no signal . On the other hand mil control circuit, open / short to b+ will delay your vw fault. |
29357 Possible Causes:
29357 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Cylinder 1 Injector Circuit Low
- Turbocharger Boost Sensor A Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 29357 Code
- Inspect all the connections data bus powertrain, implausible message of the steering angle
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns